Applying Vinyl Siding Starter Strip

The bottom of the starter strip the part the bottom panel hooks on to should be at least.

Applying vinyl siding starter strip.

This video shows how to install a starter strip for vinyl and polymer siding installation. Insulation for vinyl siding 1. This is where the new siding will begin. Cap the corner posts.

Mice bees and all sorts of other critters love making their home inside vinyl corner posts. Insert the flat hooked end of the zip tool under the lip on the bottom most edge of the vinyl siding panel that rests on top of the starter strip. Determine the lowest point of the wall that will be sided. Snap a level chalk line for the first starter strip at the base of the wall no less than 8 inches above ground level after determining the lowest corner of the house.

How to install a vinyl siding starter strip step 1. Snap each length of siding in place so that its bottom lip hooks under the starter strip. Pop a level chalk line for the starter strip an inch or two above the bottom of the siding. Pull up as.

Partly drive a nail 11 2 in. Locate the lowest possible corner that has sheathing. Position starter strip with the top edge of chalk line and allow room for corner posts. This chalk line should be level and a consistent distance from the eaves or the top and bottom of the windows.

Measure a spot that is 1 1 2 inches above the bottom edge of the sheathing at this lowest point using a tape. Hold a tape measure against the exterior wall and travel. From that point measure up 1 4 6 4mm less than the width of the starter strip and partially drive a nail at one corner. Nail vertical vinyl corners to the corners of the house making sure they are plumb.

Vinyl siding starter strips. In order for the siding to be installed properly in a level fashion the starter strip at the bottom of the wall must be level. Attach j channel trim strips around windows and doors and along the eaves. Nail the starter strip to the siding aligning the top of the strip with the chalk line.

13 simple vinyl siding installation tips use the wider starter strip. Find the lowest corner of the old siding or sheathing on the house. Staret strip secures the first course of siding to the home. Pull the zip tool down while simultaneously.